10pcs Low Voltage Waterproof Replacement Landscape Light Cable Connector 12-20 Gauge Wire Connectors for Landscape Lighting Path Lights

What It Is

These are 10 low-voltage waterproof connectors designed for splicing 12-20 gauge landscape lighting wire. They allow you to connect cable runs to path lights, spotlights, or other low-voltage fixtures without stripping or soldering.

Fitment & Compatibility

• Wire gauge: Works only with 12, 14, 16, 18, or 20 AWG solid or stranded copper wire. Do not use on aluminum or steel wire.
• Voltage: Rated for low-voltage (12-24V AC/DC) landscape lighting systems only. Not for line voltage (120V) or mower electrical systems.
• Connector type: Press-fit with a silicone gel seal—no tools required. Compatible with standard landscape lighting cable (direct burial rated).
• Check before buying: Measure your wire diameter. If you use 10-gauge or thinner than 20-gauge, these won’t fit. Ensure your fixtures have bare wire ends (no pre-attached connectors).

Key Things to Know

• Installation difficulty: Very easy—just insert wires into each side and press down the cap until it clicks. No stripping, crimping, or soldering needed.
• Waterproofing: The silicone gel inside seals out moisture, but for direct burial, bury the connector at least 6 inches deep and avoid submerging in standing water.
• Common gotcha: These connectors are single-use. Once pressed, they cannot be reused or repositioned. Plan your wire runs carefully.
• Durability: UV-resistant plastic, but not meant for high-traffic areas where they might be stepped on or run over by mowers. Install under soil or mulch.

Should You Buy It

If you’re installing or repairing low-voltage landscape lighting and need a quick, no-tool way to splice 12-20 gauge wire, these are a solid, cheap solution. They’re not for mower wiring or high-voltage use, but for landscape lights, they work reliably when installed correctly.