shiosheng Replacementparts Deflector Shield 108-7895 fit for Toro TIMECUTTER SS5000 SS5060 SS5035 Deflector Grass TimeCutter Zero Turn Riding Lawn Mower W/Hardware

What It Is

This is a replacement deflector shield (OEM part #108-7895) for Toro TimeCutter SS5000, SS5060, and SS5035 zero-turn riding mowers. It directs grass clippings downward during discharge and helps prevent debris from being thrown toward the operator or bystanders.

Fitment & Compatibility

Before buying, confirm your mower’s model number (stamped on the frame or deck) matches one of these: SS5000, SS5060, SS5035. This shield fits 50-inch and 60-inch cutting decks on those models. It is an aftermarket replacement for the OEM part, so verify your existing mounting holes align—measure the distance between the two pivot points (roughly 12 inches apart on most decks). If your deck has a different shield design (e.g., side-discharge chute vs. rear-discharge), this will not fit. Check that your hardware set matches the included bolts, washers, and cotter pins; some older decks may require separate hardware.

Key Things to Know

• Quality: At 3.7 stars, some users report the plastic is slightly thinner than OEM, which may crack under heavy use or in cold weather. Inspect for sharp edges after installation.
• Installation difficulty: Easy—remove the cotter pin and pivot bolt from the old shield, slide the new one on, and reinsert the hardware. Takes 10–15 minutes with basic hand tools.
• Common gotcha: The shield may drag on the ground if your mower deck is set at a low cutting height (below 2 inches). Adjust the deck stop or trim the shield slightly if needed.
• Hardware note: The included hardware is often generic—if the cotter pin is too long, bend it back or replace with a standard 1/8-inch pin.

Should You Buy It

If your OEM shield is cracked, missing, or worn out and you need a budget-friendly replacement for a Toro TimeCutter SS5000, SS5060, or SS5035, this will get the job done. It’s not as durable as the genuine Toro part, but for occasional residential use or as a temporary fix, it’s a solid value. Skip it if you mow commercially or need a guaranteed perfect fit—stick with OEM.