John Deere Meter AM3118E

What It Is

The John Deere Meter AM3118E is an OEM replacement metering assembly that controls the flow of granular material (fertilizer, seed, or ice melt) from a broadcast or drop spreader. It is designed for John Deere walk-behind spreaders and some tow-behind models used in lawn care and light agricultural tasks.

Fitment & Compatibility

Before buying, confirm your spreader model. The AM3118E fits John Deere spreaders such as the 100 series (e.g., 110, 120, 130) and some TS (Turf Series) models. Check your spreader’s model number (usually on a label under the hopper or on the frame). Measure the mounting hole spacing on your current meter—this part uses a 1.5-inch center-to-center bolt pattern. It is an OEM John Deere part, not aftermarket, so it will match factory specs. Does not fit older John Deere spreaders with a different meter design (e.g., 90 series or pre-2000 models). If your spreader uses a different meter (like the AM3119E), this will not interchange.

Key Things to Know

• Quality: OEM part, built to John Deere tolerances. No plastic shavings or warping issues common with cheap aftermarket copies.
• Installation difficulty: Easy. Requires removing two bolts, swapping the meter, and reattaching. No special tools needed. Takes 10–15 minutes.
• Common gotcha: The shut-off lever and spring are not included—reuse your old ones. If those are worn, order them separately (part AM3119E for the lever assembly).
• Performance: Restores precise rate control. If your spreader was leaving stripes or uneven coverage, a worn meter is often the cause.

Should You Buy It

If your John Deere spreader is dropping too much or too little material, or the adjustment dial feels loose, this meter is the correct fix. It’s a direct OEM replacement that restores factory performance. Not for you if your spreader is a different brand or an older John Deere model with a different meter design—check fitment first.