Huthbrother 692037 Wiring Harness for BS Replaces 497708 and 496070 and 495719 Models

What It Is

This wiring harness connects the ignition switch, safety interlocks, and starter solenoid on Briggs & Stratton engines found in riding mowers and lawn tractors. It replaces OEM part numbers 497708, 496070, and 495719.

Fitment & Compatibility

Before buying, confirm your engine model number (found on the valve cover or blower housing) and your mower’s make/model. This harness fits most Briggs & Stratton single-cylinder and V-twin engines with a 7-pin or 8-pin connector, but not all. Measure the length of your old harness—this one is approximately 18 inches. Compare connector shapes: the ignition switch plug is rectangular with a locking tab, and the starter solenoid connector is a flat two-prong. If your mower uses a different pin layout (e.g., 5-pin or 10-pin), this won’t work.

Key Things to Know

• Quality: Made by Huthbrother, a third-party aftermarket brand. Most buyers report it matches OEM fit, but a few note slightly thinner wire insulation. Check for any fraying before installation.
• Installation difficulty: Easy (30 minutes with basic tools). Label wires before disconnecting the old harness to avoid mix-ups. A multimeter can verify continuity if you encounter issues.
• Common gotchas: The harness may not include the fuse holder or diode that some OEM harnesses have—check your old harness for these components and transfer them if needed. Also, the color coding (red, black, white, green) matches standard Briggs wiring, but double-check your mower’s wiring diagram if it’s been modified.

Should You Buy It

If you need a quick, budget-friendly fix for a dead ignition or safety switch on a common Briggs-powered rider, this is a solid choice. It’s not for heavy-duty commercial use, but for homeowners with a basic lawn tractor, it works fine. Avoid it if your mower has a non-standard connector or requires an exact OEM match with a fuse/diode.