ECOTRIC 2 Place Weeder Trimmer Racks Holders Hold Two for Trailer Truck Tree Trimmers Edgers Pole Saws Powercoated Steel

What It Is

The ECOTRIC 2 Place Weeder Trimmer Rack is a pair of steel holders designed to securely mount two gas or electric trimmers, edgers, pole saws, or weedeaters to a trailer, truck bed, or utility rack. It’s built for transporting handheld outdoor power equipment, not for lawn mowers themselves.

Fitment & Compatibility

Before buying, measure your tool shafts: each holder accepts shafts up to 1.25 inches in diameter. The rack itself mounts to any flat surface (trailer rails, truck bed sides, or utility rack) with a minimum 2-inch-wide mounting point. Bolt pattern is universal—uses 3/8-inch hardware (not included). Works with most straight-shaft trimmers and edgers, but curved-shaft or oversized heads may not fit securely. Not compatible with zero-turn mowers or riding mowers directly; it’s strictly a transport accessory.

Key Things to Know

• Installation difficulty: Easy. Requires drilling or pre-existing holes in your mounting surface; hardware and basic tools needed (drill, wrench, socket set). Expect 15–30 minutes.
• Build quality: Powder-coated steel resists rust, but the coating can chip if tools are repeatedly slid in and out. Plastic sleeves inside prevent scratches, but they may wear over time.
• Common gotcha: The rack holds tools by the shaft only—heavy or long equipment (like pole saws) may wobble or tip if not balanced. Use bungee cords or straps for extra security during transport.
• Space needed: Each holder is about 8 inches apart; measure your trailer or truck bed width to ensure both tools fit without interfering with each other or other cargo.

Should You Buy It

If you regularly transport two straight-shaft trimmers, edgers, or pole saws in a truck or trailer and want a cheap, no-frills storage solution, this rack works well. Skip it if you have curved-shaft tools, need quick-release mounts, or want a heavy-duty setup for daily commercial use—look for a locking or clamp-style system instead.