4 Pack Replacement Yellow SPOUT CAPS Top Hat Style fits # 900302 900092 Blitz Gas Can Spout Cap fits self Venting Gas can Aftermarket (SPOUTS NOT Included)

What It Is

This is a set of four replacement yellow top-hat-style spout caps designed for self-venting Blitz gas can spouts (models #900302 and #900092). They seal the spout opening when not in use and are intended for lawn mower, trimmer, and other small engine fuel containers.

Fitment & Compatibility

• Exact fit: Works only with Blitz self-venting spouts that use the “top hat” cap design (flat top with a small stem). Not compatible with standard twist-on or push-in caps.
• Check your cap: Measure the inner diameter of the cap opening – it should be roughly 1.5 inches. The stem length is about 0.75 inches.
• Spouts NOT included: These are caps only. You must already own a compatible Blitz spout (models 900302 or 900092) or an aftermarket spout that uses the same cap style.
• Not universal: Will not fit older Blitz spouts without the self-venting top-hat design, nor other brands like Scepter, VP Racing, or No-Spill.

Key Things to Know

• Material quality: Made of yellow plastic that matches the original Blitz color. Some users report the plastic is slightly thinner than OEM, but it seals well.
• Installation: Push the cap onto the spout until it snaps into place. No tools required. Ensure the cap is fully seated to prevent fuel leaks or evaporation.
• Self-venting check: These caps are designed to allow air into the can as you pour. If the cap doesn’t vent properly, the spout may gurgle or stop flowing – clean the cap’s small vent hole with a pin if needed.
• Pack of four: Good for multiple gas cans or as backup spares. Each cap is identical.

Should You Buy It

Buy this if you own a Blitz self-venting spout (900302 or 900092) and need a cheap, functional replacement cap – especially if yours is cracked, lost, or leaking. Skip it if your spout uses a different cap style or if you need a complete spout assembly.