2 Pack 13x5.00-6" Lawn Mower Tires with Rim,13x5x6 Tiller Tire With Wheel with 3-1/8" Center Bore,1" Axle Bore Hole,4 Ply Lawn Garden Turf Tire and Wheel Assembly

What It Is

This is a 2-pack of 13x5.00-6 lawn mower tires mounted on steel rims, designed as a direct replacement for front or rear wheels on ride-on mowers, garden tractors, tillers, and small utility trailers. The 4-ply turf tread provides low ground pressure to avoid damaging lawns.

Fitment & Compatibility

Before buying, verify these four measurements:

• Tire size: Must be 13x5.00-6 (13" outer diameter, 5" wide, 6" rim diameter). Common on Craftsman, MTD, Husqvarna, and John Deere models.
• Center bore: 3-1/8" – this is the hole in the center of the wheel. Measure your old wheel’s center hole; if it’s smaller, this wheel won’t fit.
• Axle bore: 1" – the axle hole must match your mower’s axle diameter. Common on most lawn tractors, but some use 3/4" or 5/8".
• Bolt pattern: Not listed – this is a universal fit with no bolt holes. It uses a single center axle hole and a keyway or set screw. Confirm your mower uses this style, not a multi-bolt hub.

Check your mower’s manual or measure your old wheel’s center bore and axle hole. These are aftermarket replacements – not OEM, but widely compatible.

Key Things to Know

• Installation: Simple – remove old wheel, slide new one onto axle, tighten nut or cotter pin. No special tools needed. May require a 1" bushing if your axle is smaller.
• Quality: 4-ply rating is standard for residential mowers. Tire pressure should be 15-20 PSI; under-inflating can cause rim damage.
• Gotcha: The 1" axle bore may be too large for some older or compact tractors. Measure your axle diameter before ordering. If it’s 3/4", you’ll need a bushing adapter.
• Tread: Turf-style – fine for grass, poor on wet slopes or mud. Not for aggressive off-road use.

Should You Buy It

Buy this if you need a budget-friendly, direct replacement for a worn or damaged 13x5.00-6 tire/rim combo on a standard lawn tractor or tiller, and your axle is 1" with a 3-1/8" center bore. Avoid if your mower uses a multi-bolt hub or a non-standard axle size.