17910-VL0-B00 Throttle Control Cable Fit for Honda HRR216 HRN216 Walk-Behind Mower, Replacement for 17910VL0B0 17910-VL0-B01, Fits Blade Brake Models with GCV160 GCV170 Engine

What It Is

This is a genuine Honda throttle control cable that connects the throttle lever on the handle to the carburetor on GCV160/GCV170 engines. It controls engine speed (full choke, fast, slow, stop) on blade brake-equipped Honda walk-behind mowers like the HRR216 and HRN216 series.

Fitment & Compatibility

Before buying, confirm your mower has a blade brake system (the blade stops when you release the handle, but the engine keeps running). This cable will NOT work on manual-clutch or fixed-deck models without a blade brake.

Check these specifics:

• Engine: Must be GCV160 or GCV170 (check the engine label, not just the mower model)
• Mower models: HRR216K9, HRR216K10, HRN216VKA, HRN216VLA, and similar HRR/HRN series with blade brake
• OEM part numbers: Replaces 17910-VL0-B0, 17910-VL0-B01 – verify your old cable’s part number
• Cable length: Approximately 42 inches from end to end – measure your old cable to be certain
• Deck size: Fits 21-inch decks – no compatibility with 18-inch or 22-inch models

Key Things to Know

• Genuine Honda quality – not an aftermarket knockoff. The cable housing is durable, and the end fittings snap into place precisely. Expect OEM-level longevity (3-5 years in normal use).
• Installation difficulty: Moderate – requires removing the handle cover, disconnecting the old cable from both the lever and carburetor linkage, and routing the new cable through the same path. A 10mm socket, Phillips screwdriver, and needle-nose pliers are needed.
• Common gotcha: The cable end at the carburetor has a small plastic retaining clip that can break if forced. Apply a drop of silicone spray to the cable before routing to reduce friction.
• No adjustment needed – the cable is pre-set to the correct length. Just snap it into the lever and carburetor bracket, then test full range of motion before reassembling.

Should You Buy It

If your Honda HRR216 or HRN216 with a GCV160/GCV170 engine has a sticky, loose, or broken throttle cable, this is the correct OEM replacement. It’s priced fairly for genuine Honda quality and installs without modification. Skip it if you have a non-blade-brake model or a different engine series.