130794 Spindle Assembly with 153535 Pulley Fit for 38 42 inch Deck Craftsman LT1000 LT2000 LTX1000 DLT3000 DYT4000 Husqvarna Poulan Pro Lawn Mower Replaces 532130794 128774 128285 (2 Pack)

What It Is

This 2-pack spindle assembly with pre-installed pulley (part 130794/153535) replaces the factory blade spindle on 38- and 42-inch decks used by Craftsman LT1000/LT2000/LTX1000/DLT3000/DYT4000, plus Husqvarna and Poulan Pro lawn tractors. It drives the blade at the correct speed and height while supporting the belt routing.

Fitment & Compatibility

Before buying, confirm your deck width is exactly 38 or 42 inches (measure blade tip to blade tip). The assembly replaces OEM part numbers 532130794, 128774, and 128285. It fits most Craftsman LT/DTL/DYT series tractors with stamped steel decks, plus Husqvarna and Poulan Pro models using the same spindle pattern. Check that your deck uses a 5/8-inch spindle shaft (common on these brands). Verify the pulley diameter matches your original (typically 4-inch on 42-inch decks, 3.5-inch on 38-inch). If your deck uses a different pulley size or offset, this kit won’t align belts correctly.

Key Things to Know

• Quality: Aftermarket housing is cast iron (same as OEM); pulley is steel. Expect comparable durability to factory parts, but grease fittings may be absent—add grease before installation if possible.
• Installation difficulty: Moderate. You’ll need a socket set, possibly a puller for stubborn old spindles, and a torque wrench. Expect 30–60 minutes per spindle.
• Common gotcha: The pre-installed pulley nut is often overtightened from the factory. Check for smooth rotation before mounting—if it binds, loosen the nut slightly and re-torque to 30–35 ft-lbs.
• Deck removal not required on most models, but you’ll need to raise the deck and block it securely. Access the spindle from above (belt side) and below (blade side).

Should You Buy It

If you’re replacing worn or wobbly spindles on a 38- or 42-inch Craftsman, Husqvarna, or Poulan Pro tractor, this 2-pack is a solid value at $44.99—cheaper than OEM singles and well-reviewed for fit and performance. It’s right for DIY owners who want a direct bolt-in replacement without hunting for separate pulleys. Avoid if your deck uses a non-standard spindle pattern or if you need greasable units for heavy commercial use.