120-7011 Trailing Shield Flap Compatible with 21" Toro Walk Lawnmower, Replacement 107-7496, 114-1586 (1-Pack)

What It Is

The 120-7011 is a replacement trailing shield flap for 21-inch Toro walk-behind lawn mowers. It mounts at the rear of the cutting deck to direct grass clippings downward and reduce debris kickback—critical for safety and a clean cut.

Fitment & Compatibility

• Fits: 21-inch Toro walk-behind mowers (e.g., Personal Pace, Recycler, Super Recycler, and TimeCutter models with rear-discharge decks).
• Replaces OEM part numbers: 107-7496 and 114-1586.
• What to check before buying:
  • Measure your existing flap’s width (should be roughly 21 inches across).
  • Confirm your deck has two mounting holes spaced about 6 inches apart (center-to-center) on the rear lip.
  • Verify your mower’s model number (stamped under the seat or on the deck) against Toro’s compatibility list—this flap does not fit all 21-inch decks (e.g., some Super Recycler models use a different shape).
• Aftermarket note: This is a non-OEM replacement; material may be slightly stiffer or thinner than the original Toro part.

Key Things to Know

• Installation difficulty: Easy—remove two bolts or push-pins, swap flaps, and reinstall. No tools required for most models (pin-style retainers).
• Material: Rubberized composite; UV-resistant but may crack over time if stored in direct sunlight.
• Common gotchas:
  • The flap may drag on the ground if your deck height is set low (1–1.5 inches). Trim 1/4 inch off the bottom if needed—use sharp scissors.
  • Some users report the aftermarket flap is slightly narrower than OEM, leaving a small gap at the edges. This can reduce mulching efficiency.
• Durability: Expect 1–2 seasons of regular use before replacement; heavy use or rocky terrain may shorten lifespan.

Should You Buy It

Buy this if you need a quick, budget-friendly replacement for a worn or torn trailing shield on a 21-inch Toro mower and don’t mind a slightly non-OEM fit. It’s ideal for basic grass cutting and rear-discharge setups. Avoid it if you require exact OEM dimensions for mulching or if your deck uses a different mounting pattern—stick with genuine Toro 107-7496 or 114-1586 instead.